Material Safety Data Sheet
Manufacturer’s Name: Crystal Packaging, Inc.
Address: 5185 National Western Dr. Telephone Number: 303-778-1805
Denver, CO 80216 Date Prepared: May 25,2008
PRODUCT NAME: FOAMY 1
SECTION II: Hazardous Ingredients/Identity Information
Hazardous Components CAS# OSHA PEL ACGIH TLV Other
Ethylene Glycol 111-76-2 50ppm 25ppm MAK: 20ppm
Monobutyl Ether skin skin skin
SECTION III: Physical/Chemical Characteristics
Boiling Point: Approximately 195ºF Specific Gravity: 1.043
Vapor Pressure: NA Melting Point: NA
Vapor Density: Heavier than air Evaporation Rate: Slower than ether
Solubility in water: Complete
Appearance and Odor: Light blue with mild scent.
SECTION IV: Fire and Explosion Hazard Data
Flash Point: Liquid non-flammable.
Flammable Limits: NA LEL: NA UEL: NA
Extinguishing Media: Carbon dioxide, dry chemical, foam or water.
Class A, BC, or ABC fire extinguishers.
Special Fire Fighting Procedures: Water can be used to cool containers adjacent to fire
Unusual Fire and Explosion Hazards: Pressure may develop in closed containers if temperatures over 195°F are reached.
SECTION V: Reactivity Data
Conditions to Avoid: NA
Incompatibility: Strong oxidizing agents or anything reactive with water.
Hazardous Decomposition or Byproducts: Carbon monoxide, carbon dioxide, and smoke.
Hazardous Polymerization: Will not occur.
Conditions to Avoid: NA
SECTION VI: Health Hazard Data
Routes of Entry: Eye contact, Skin contact, Inhalation, and Ingestion
Effects of Overexposure
Eyes: Contact will painful and irritating.
Skin: Prolonged contact may cause irritation.
Inhalation: Will irritate nose, throat and chest.
Ingestion: May cause nausea, vomiting, and or diarrhea.
Emergency and First Aid Procedures
Eyes: Flush with water for 15 minutes. Contact a physician if needed.
Skin: Remove contaminated clothing, flush contact area with water.
Inhalation: Remove to fresh air. If any symptoms persist, contact a physician immediately.
Ingestion: Dilute with water and induce vomiting. Contact a physician immediately.
SECTION VII: Precautions for Safe Handling and Use
Steps to be taken in Case Material is released or spilled: For minor spills soak up with sweeping compound and or sand and transfer to a disposal container.
Waste Disposal Method: Incinerate or dispose in accordance with all federal, state, and local regulations.
Precautions to Be Taken in Handling and Storing: Storage between 40°F and 100°F are recommended.
Other Precautions: Do not take internally or inhale vapors. Avoid eye contact.
SECTION VIII: Control Measure
Respiratory: Not normally needed.
Local Exhaust: Preferable
Mechanical (General): Acceptable
Protective Gloves: Plastic or NBR gloves
Eye Protection: Chemical safety goggles
Other Protective Clothing or Equipment: Usually not needed unless splashing is excessive.
NI – No Information NA – Not Available